机械5

其它技术要求: OTHER SPECIFICATION REQUIREMENT 1、筒体、封头及其相互间对接焊全截面焊透。 The butt joi
nts for shell,heads a
nd others shall be full fusio
nweldi
ng. 2、设备不锈钢表面需清除油污做酸洗钝化处理,对所形成的钝化膜进行蓝点法检查,无蓝点为合格。 THE EQUIPMENT SHOULD BE PICKLING&SUBLIMATE AFTER FABRICATION ON STAINLESS STELL.SUBLIMATE FILM HAVE BLUEPOINT METHOD TEST. WITHOUT BLOEPOINT IS QUALIFIND. 3、设备碳钢部分外表面油漆以及包装、运输按JB/T4711-2003规定。 THE BEADED PAINT SUM OF THE AETIOPORPHYRIN FURNISHED THE BALE TRANSPORT CLICK JB/T4711-2003 SPECIFIED. 4、设备管口支座方位按俯视图。 THE ORIENTATION OF THE FURNISHED SEE PLAN VIEW. 5、进行液压试验时,应控制水中的氯离子含量不超过25mg/L,试验合格后应立即将水渍清除干净。 THE AFTER HYDRAOLICALLY TESTED,THE DROP OF WATER SHOLUD OFF OR THE CHIORIDE ION'S CONIENT IN WATER SHOULD BE CONTROLED LESS THAN 25mg/L. 6、与物料接触部份(内挡板的上沿至釜底)抛光300#。 7、夹套水压试验时,内筒需充压0.033Mpa。